Search results

We did the first AEV non factory lift on a RAM early this year. The kit is very impressive and performs very well on and off road. We like AEV products as they perform above expectations and they fit right out of the box. The AEV product are well engineered, well made, and achieve the required...

2014 Chaser Trailer Fully equipped trailer with many unique extras. All of the after sale installation and maintenance done by AT. This is a well cared for trailer that we know well. Price $20,966.00 Pneumatic tongue jack Nose box 12volt system Dual Battery system, AGM Group 31 Dual Battery...

The wave heater is un-vented. The safety warning is: Safety Note: Any fuel burning ventless appliance needs adequate air exchange to replenish Oxygen and remove products of combustion. Standards require at least a 1 square inch fresh air opening for every 1000 BTUs of propane used by any...

Had a few messages people wanting to know if the trailer is still for sale, yes it is. Very well cared for trailer, fully equipped, ready to go. All you need is you clothes and some food.

George, the simple answer to your questions is vehicles and trailers start to fall apart when you take them off-road, the biggest offender is wash board roads, they will vibrate almost anything to death. Add to that the occasional obstacle that happens to be in the way, and the drop off you...

We are selling a 2006 Horizon for a customer. This trailer has been very well cared for and upgraded. To be sold as a package. Horizon 2006 Price $ 13,120.00 Nose Box with tread plate lid Fuel Can Set (cans not shown in pictures) Water tank, 20 gallons, with aftermarket on demand water pump...

I too would recommend the Go-Power Overlander Solar Kit 160 watt panel. The great thing about this product is it continues to provide good amperage in low sunlight, clouds, early morning, late afternoon, dappled sunlight etc. We have tested various panels and they all provide good power in...

If your amperage draw was less than the alternator output, then it sounds like you had some issue with the voltage regulator. If you can't replicate it you have to hope it was a one off occurrence.

To be safe I would put in a Low Voltage Disconnect between the main starter battery and the 12 volt socket that the fridge will be running off. We sell a LVD that has an adjustable cut off point, so you could set the cut off at 11.5 volts and still have plenty of power to start the vehicle...

A few thoughts for you. Trailer roll overs are the exception, but they are dramatic when they occur and people like to talk about them. The result is people think they happen all the time. From experience we can tell you that AT Trailers have been over the Rubicon Trail with multi axis...

There are a few ways to think about the multi axis coupler. 1) It allows articulation beyond that of a ball coupler without risking becoming detached. 2) It allows the trailer to roll over when a more solid connection may cause the vehicle to also roll, (think off camber situations). Roll...

Hot dip Galvanizing would be the best solution, it's a little more complicated as the frame has already been made and has started rusting. You also have to build in expansion holes and fill holes in the chassis to allow the expanding gases to escape and the molten zinc to drain. Beyond that, as...

Really doesn't matter who's trailer it is, SEMA isn't able follow their own rules if Shutt doesn't have a booth inside. I don't begrudge anyone wanting to display a vehicle outside at SEMA, I just think the rules should be enforced universally or not at all.

We insulated the cavities on a van using foam. The flat panels we insulated with styrofoam sheets. Worked out very well. I initially looked at the two part kits but after looking at the volumes required and the difficulty getting a kit of the right size I decided upon cans of insulating foam. A...

Interesting to see the Xventure Trailer being exhibited. We had a long standing argument with SEMA regarding exhibiting AT trailers at the show, they insisted that as a manufacturer we should have a booth inside to qualify for exhibiting a trailer outside. We argued that the trailer was a...

We sell a rear stabilizer that may do the trick for you. You can see it here

Chris, we have the swivel and the bracket worked ot and ready to go. I'm working on a source for tires and mini axles. These little wheels, tires, and axles are quite a learning experience.